I’m new at these engines and was wondering if it is possible to
build an engine that would work using a cylinder 110mm in diameter
by 180mm long, what would the size of the power cylinder need to be?
Is it even possible with this length or will i need to cut it down?
Is there some kind of ratio or formula I should follow? Any
information will be greatly appreciated. Thanks
cylinder sizes ???
Moderator: stan.hornbaker
Forum rules
Be nice!
Be nice!
-
- Posts: 1
- Joined: Tue May 24, 2005 9:19 pm
- First Name: bob
- Last Name: frank
-
- Posts: 3
- Joined: Mon Nov 06, 2006 2:35 am
- First Name: Daniel
- Last Name: O'Connor
Response to cylinder sizes ???
Hi, The lenght of the displacer cylinder should be 3 times the diameter.
-
- Posts: 13
- Joined: Tue Nov 25, 2008 12:52 am
- First Name: Qamarul
- Last Name: Hazimin
Response to cylinder sizes ???
for displacer the dimension should be 3:1 (length to diameter ratio) and also the swept volume ratio should be 1.33:1(Vswept for displacer to Vswept for power piston)