cylinder sizes ???
Posted: Tue May 24, 2005 9:37 pm
I’m new at these engines and was wondering if it is possible to
build an engine that would work using a cylinder 110mm in diameter
by 180mm long, what would the size of the power cylinder need to be?
Is it even possible with this length or will i need to cut it down?
Is there some kind of ratio or formula I should follow? Any
information will be greatly appreciated. Thanks
build an engine that would work using a cylinder 110mm in diameter
by 180mm long, what would the size of the power cylinder need to be?
Is it even possible with this length or will i need to cut it down?
Is there some kind of ratio or formula I should follow? Any
information will be greatly appreciated. Thanks