Piston rings, rulon LD, where to buy?
Posted: Thu Dec 21, 2006 10:18 am
Hello!
I'm trying to get 500w out of my alfa, so far not even close but here
you can see it running http://www.youtube.com/watch?v=9Bf6mhfeUH0&eurl=
Piston diameter is 63mm and now I'm seeking to find small pieces of
rulon LD sheet, 0.25mm thick, to try to make lip seals. I got these
informations from Mr. Andy Ross's book, but does anyone know if I
needed a thicker material to piston with 63mm bore?
63mm should be a standard bore, I would be happy to try a factory made
piston rings if there was any suitable low friction / high temperature
rings available? Is there any?
Teemu Häyrinen / Finland
I'm trying to get 500w out of my alfa, so far not even close but here
you can see it running http://www.youtube.com/watch?v=9Bf6mhfeUH0&eurl=
Piston diameter is 63mm and now I'm seeking to find small pieces of
rulon LD sheet, 0.25mm thick, to try to make lip seals. I got these
informations from Mr. Andy Ross's book, but does anyone know if I
needed a thicker material to piston with 63mm bore?
63mm should be a standard bore, I would be happy to try a factory made
piston rings if there was any suitable low friction / high temperature
rings available? Is there any?
Teemu Häyrinen / Finland