crankshaft

Moderator: stan.hornbaker

Forum rules
Be nice!
Post Reply
radiomelon
Posts: 1
Joined: Fri Mar 28, 2003 12:25 am
First Name: Jacob
Last Name: Snyder

crankshaft

Post by radiomelon »

My question regards the different distances that form the lever arms
for the power and displacer cylinders. I've noticed that most
designs use a power cylinder to displacer cylinder lever arm ratio
of around .3333 or .4444. Is there any kind of "rule of thumb for
determining the distaces of the lever arms? I know the displacer
should move far enough to almost touch the inner surfaces, but is
there a guideline for how long the power cylinder lever arm should
be with respect to the displacer lever arm?
Post Reply