Hi, I am new to the forum, new to Stirling engines.
I am a senior at eastern washington university and am currently
trying to build a prototype Stirling engine using these plans:
http://heetgasmodelbouw.ridders.nu/Webp ... g_hand/han
dstirling_frameset.htm
or this link if the other doesn't work:
http://tinyurl.com/22atan
They are German or Belgian? I'm not sure.
We have a similar design and it really wants to run, but there is not
quite enough to make it go. We have tried to reduce friction as much
as possible, but I fear that it is not enough.
What are some effecient ways to make the connecting rods so they are
free and don't bind?
The bearings I am using may be lightly oiled, should I clean them out?
We are using a 1/2" dia. graphite piston in a brass cylinder, is that
ok?
Is there a simpler way to make this engine? We have been tinkering
with it for two weeks to no avail. I can post pictures if that will
help.
Thanks,
Arron Thompson
Spokane, WA 99205
I'm having trouble, and need some help
Moderator: stan.hornbaker
Forum rules
Be nice!
Be nice!